When installing the Anna engraving knife, first check the diameter model of the rod. The CB09 thin rod is suitable for thin materials, and the CB15 thick rod should be suitable for thick films. The length of the knife extension should be controlled at 1.5-2mm. If it is too long, it is easy to break the tip, and if it is too short, it cannot cut through the material. Choose the angle according to your needs, specializing in fine small characters and fine line patterns at 30 °, universal for daily car stickers and stickers at 45 °, and effortless for cutting reflective film, thick car clothes, and heat transfer film at 60 °.
Adjust the pressure speed of the engraving machine, lower the pressure of the new blade by 5-10 gears, and use high-speed cutting to avoid blade cracking; Slow down the speed of thick materials and apply slight pressure to prevent burrs from drawing. Before processing, it is necessary to make a trial cut to check whether the base paper is half broken and the cut surface is flat.
Clean up the residual glue on the knife holder in a timely manner after use. The accumulation of residual glue will offset the concentricity and cause distortion of the lines. Do not remove the cutting tool for a long time, gently wipe the edge with rust proof oil and store it. Do not forcefully apply pressure when there is difficulty cutting or jagged lines, as it is often due to worn edges. Replace the blade directly with a new one. It is strictly prohibited to collide with the tip of the knife. Hard alloy is brittle and hard, and slight impact will result in scrap. Handle with care to extend the service life of the tool.
