3D Carving Knife (Cemented Carbide)

22 6月 2021 | 没有评论 | posted by admin | in Article

Main functions: three-dimensional corner clearing, chamfering
Applicable material: organic, PVC. Can also be used for: MDF, medium hard wood
Matters needing attention: Regardless of whether it is engraving or reverse engraving, be sure to keep the engraving plane flat; it is very important to choose a suitable blade width for three-dimensional clear-angle engraving. It is recommended that the blade width of small-format engraving machine should not exceed 22MM, and the large-format engraving machine should A tool with a suitable blade width can speed up the engraving speed.

Right Angle Milling Head

21 6月 2021 | 没有评论 | posted by admin | in Article

Right-angle milling heads are also called transverse milling heads or horizontal milling heads, which refer to milling heads whose tool output shaft is parallel to the horizontal plane.
The right-angle milling head can realize the vertical-horizontal conversion of the vertical machining center, which is used for the side machining of the workpiece, which reduces the number of clamping times of the workpiece and greatly improves the machining accuracy.

What is the difference between left-handed and right-handed cutting and right-handed and right-handed cutting of milling cutters

18 6月 2021 | 没有评论 | posted by admin | in Article

It can be seen from the mode of action of the thread that when the thread is rotated, if it is not forced to “screw in”, the “in” will be the nut. Compared with the milling cutter, it is the chips cut off during milling. It can be seen that when the rotation direction of the milling cutter remains unchanged, the chip removal direction of the left and right rotary milling cutter is also different.

　　 Because in milling, the rotation direction of the left-hand milling cutter must be the same as that of the right-hand milling cutter, in order to change the chip removal direction. Therefore, for the left-handed milling cutter with the purpose of changing the chip removal direction, the cutting edge direction must also be the same as that of the right-handed milling cutter, that is, “right cutting”.