A leaf decal can have a clean edge and still look misplaced on a display wall. Start with one closed leaf outline at the intended size. JEEFOO lists its 45° Summa-type blade for vinyl decals on compatible plotters. Check the holder match, cut a sample and weed it. Inspect the pointed end before copying the shape.

Half-drop leaf decals: three columns of green leaf decals on a display wall, with the middle column staggered lower
Half-drop leaf decals: three columns of green leaf decals on a display wall, with the middle column staggered lower

For a matt sample, ORACAL 631 has removable adhesive. Try the complete transfer on a spare piece with the intended wall finish. ORAFOL requires users to test compatibility with the selected paint. Record the paint check alongside the cut leaf.

Now lay out three columns of upright leaves for half-drop leaf decals. Suppose their top tips repeat every 400 mm vertically. Put the first tip 100 mm below a common top line in columns one and three, but 300 mm below it in column two. That 200 mm difference is the half-drop. Graham & Brown describes the same pattern arrangement in wallpaper, where alternate strips repeat at the ceiling.

Mark the column numbers on the drawing. Within each column, measure tip to tip. Across the columns, check 100, 300 and 100 mm from the same top line. Moving the middle column up until all three tips line up changes the approved pattern. Keep the stagger in the layout and test the leaf shape separately before cutting the full set.

Sources

  1. 45° Summa-type blade
  2. ORAFOL datasheet
  3. Graham & Brown wallpaper FAQ

Related reading: a Summa 45° blade test cut for a shaped bokeh heart. Also see how a Summa-type carbide blade responds to a magnet.

Recent articles

Subscribe to our newsletter

No Spam! Just valuable content — straight to your inbox.